To address the wire mess I created, at the back of the LCD screen I needed a place that I can tag onto my frame and then slip a wire tie to hold the wires in place.

This was one of those quick 15 minute prints that I thought about and had printed inside an hour. I need something that I can screw down and pop in a cable tie and hold down some wires neatly.
I also printed the other hinge but this time in a vertical orientation. The cleanup of support material changed from the narrow slots to the hinge area. It also took 2 hours to print and used a lot more filament.
The image below shows the clips and mounting for the Raspberry pi.
Both hinges added, I have not tie wrapped the wires yet.
